Shore Hardness Tester Shore Durometer Rubber Tire Hardness Tester Meter O D A-Type 0-100 Ha For Plastic Leather

Note: Type O hardness tester is used to measure hard sponges and foamed sponges. If a very soft sponge or a higher requirement, a special foam hardness tester is required.

Selection guidance:
Shore hardness tester is specially used for rubber hardness measurement;

Type A is used for hardness below 70;

Type D is used for hardness above 70,

Type O is used for foam sponge;

Sponge hardness tester
If you don't know the hardness of the object to be measured, first use a nail or pen to press vertically. If there is an indentation, use type A, and if there is no indentation, use type D.

Main parameters:
Dial value: 0-100 degrees
Needle stroke: 0-2.5mm

Needle end pressure:
A / C type 0.55N-8.06N, D type 0-44.5N