Red/Blue/Green Led Display 6 Digits 0.1Mhz~65Mhz Digital Rf Frequency Meter Counter Tester Cymometer Plj-6Led-A Dc 8V~15V
- 139 reviews
- 144 Sold
USD $7.60VAT Included50% OFFFree Shipping
Just for Dropshipping and Wholesale
Customer Reviews
*Note: Some reviews have been processed by Google Translate!DIY Supplies: ELECTRICAL
Display Type: Digital Only
Certification: CE
Measuring Range: 0.1MHz~65MHz
Dimensions: 9cm x 2.5cm x 2cm
Operating Temperature: 0-50c
Model Number: PLJ-6LED-A Frequency Meter
Accuracy Class: /
Voltage: DC 8V~15V
Reference description:
PLJ-6LED-A is a cost-effective six-digit LED frequency display module specially designed for forum HAM friends. It is mainly used to display the frequency value of transceivers and other equipment, and can also be used for regular frequency measurement. This module has the characteristics of small and exquisite, reliable performance, good visual effect and low cost.
Technical Parameters:
1. Gate time
0.1 second
2. Measurement channel
Input impedance: high impedance
Measuring range: 0.1 MHz~65 MHz
Measurement accuracy: 10 Hz
Sensitivity: better than 60mVpp
3. IF setting
Independent dual intermediate frequency design, the minimum step of intermediate frequency adjustment is 100Hz, the intermediate frequency range is 0~99.9999MHz, and the mode of adding intermediate frequency or subtracting intermediate frequency can be set.
4. Frequency reference
Using 5032 package 13.000MHz Temperature Compensated Voltage Controlled Crystal Oscillator (VC-TCXO), the frequency stability is ±2.5ppm.
5. Working voltage
DC input: DC8V~15V (with power reverse polarity protection) or DC5V (hardware setting required).
5. Working current
Max 90mA
7. Display digits
Six-digit common anode LED display, the highest display six digits.
8. Display brightness
Eight-level LED brightness is adjustable, and the factory setting is the highest brightness.
9. Physical dimensions
Length × width × height: 91mm×28mm×20mm
10. Onboard interface
RF IN (signal input): HX2.54-2P socket
ICSP (programming interface): 2.54-6P pin
DC IN (power interface): HX2.54-2P socket
Package Included:
1 *frequency counter
2 *connecting wires
Pre-amplification:
The radio frequency signal enters the pre-wideband amplification from RF IN.
The signal amplification is composed of dual-gate FETs BF998R, C3356 and its peripheral components with extremely high input impedance. The 50K trimming resistor adjusts the C3356 operating point to change the channel sensitivity. After amplification, the signal enters the MCU RA4 for counting, and the Schmitt trigger in RA4 The converter acts as a signal shaping.
MCU control:
RB1 and RB2 of PIC16F628A are the clock and data control terminals of TM1637 respectively. RA6 and RA7 serve as the online programming interface ICSP, and are also the control terminals for dual-IF switching and the last bit display blanking. RA4 counts external pulses and RA3 controls the gate.
Display and key control: