Why do you see a little different CNC in the photo? And all because-that I came a set with completely killed table bearings (and the carriage bearings are ideal, which is amazing, so that I do not even think about changing them) and I decided to interfere immediately with the design, turning partially into "rails", and if you have a 3D printer, then it's not difficult to do it. While the process is not yet complete, but how it is already working-I like it. Then I'll add a review when I finish the modification-it remains to fix from below the crossbar, for which I will move the updated Y axis (the last photo, will be be be Evaluation did not decrease, because. All the rest without any defects, including absolutely straight shafts and running screws, only these four bearings, and the price of the kit is low to require 100% of the quality of it to all. By the way, the motor with the cartridge almost does not beat and it turns out to be even a little better to count.

Excellent machine, complete complete set of very decent quality, from the seller the link to the documentation is complete. While only used an autonomous operation controller, you can adjust the pitch of the milling cutter from 0,1 to 10mm, there is a cable for connecting to the computer and the installation disc. Everything is clear and clear-this is the first Step. Now I'll try it online. I'll write it up. We need to figure it out. Now the engine has been running for an hour at idle heating of the shd do not observe, before this 20 minutes on load (chipboard), also do not warm. In a set of 10 cutters, the spindle is already installed. On the Motherboard there are connectors for connecting Laser, I.E. You remove the spindle unit and install the laser unit.

Everything is very well packed, simple and clear when assembled. There is a confusion with the axes, the engines were connected to the control board at random, the direction of movement along the x axis when manually controlled in the end turned to the reverse,, but Some bearings of the slide turned out to be with a small backlash, but when assembled everything turned out hard, without backlash, the axis of sliding is perfectly smooth, the plastic parts parts parts The head of course will spring when pressing due to the bending of the axes of sliding, but the impressions are as positive as possible, let's see the machine in operation!

Machine working. Going easy. All the bolts in the kit were put with a margin. The details came in a metal chip, it is necessary to carefully clean before assembling. On the axes a little sticks in the extreme positions, the X axis has already developed, the y axis is still jamming. Milling cutters in a set of low quality-it looks like a former in use. The board has a connector for Z probe.

Came very quickly-in 5 days. Without damage, full set. Software and detailed assembly instructions allow you to start the unit in a short time. Confuses the absence in the proposed set of limit switches. Of course, it will work without them, but their connection would exclude emergency situations. But if you need them, you can buy them separately. To the seller-thank you.